Liste des Groupes | Revenir à e design |
On Mon, 3 Jun 2024 07:52:58 -0700, Don Y <blockedofcourse@foo.invalid>
wrote:
Presumably, one should feel comfortable using a device at the published
operating temperature extremes "forever".
>
But, what sort of derating likely went into that specification in the
first place? Sad another way, how much *beyond* those limits might want
suspect you could operate the device?
I don't think that there are any standards that manufacturers use to
make datasheet abs max specs.
I like to test parts to destruction and estimate what they can actually
do. For example, max voltage ratings can sometimes be safely exceeded,
or a surface-mount resistor can dump a lot of power if it's well heat
sunk with copper pours.
Thermal imaging can quantify hot-spot temperatures.
Pushing parts past specs is only a good idea if there is a serious
performance upside.
RF parts are especially likely to be under-rated. Like a 2 volt rated
schottly detector diode that starts to leak at 7. Or RF amp parts that
actually run at 2x rated max voltage in normal use.
GaN fets are interesting. As are mosfets that avalanche at some
unspecified voltage.
A bit of air flow can really change things. I assume that most specs are
based on still air.
I've seen a few parts that were unreliable within their abs max specs
and needed to be derated from there.
Blow up some parts. It's fun.
Les messages affichés proviennent d'usenet.