Re: DC relay latching voltage

On 2024-08-25 2:07 a.m., Don Y wrote:

On 8/25/2024 2:03 AM, Don Y wrote:

On 8/25/2024 12:40 AM, piglet wrote:

An even simpler coil catcher is a resistor. Many times the extra power
consumption is not an issue and resistors are even cheaper and more
reliable than zener + diode.

A lot depends on the relay's (coil) duty cycle.

To limit the peak transient (to approximately the supply voltage) when
the coil opens, R needs to be on the order of the coil resistance.
If the this halves the load resistance that must be driven when the
coil is active.

Of course, if the duty cycle is low and 2X the driving current is
within the capabilities of the device you had already planned on
using for the switch, then this has minimal impact.

OTOH, if the coil current is higher, already taxing the capabilities
of the switch or the duty cycle has the coil energized more often
than not, then this can be a significant factor.

And, as R approaches the coil's resistance, the opening time/delay of
the relay *increases*.  I.e., you want R to approach infinity to get the
best opening transition but this also gives the highest switching
transient voltage -- often many times the supply voltage!

<https://www.te.com/commerce/DocumentDelivery/DDEController?
Action=srchrtrv&DocNm=13C3311_AppNote&DocType=CS&DocLang=EN>

Is there an index to these useful Application Notes?
I only found this when I searched for "application notes":

https://www.te.com/en/products/relays-and-contactors/relays/intersection/application-notes.html

And did you happen to write some of them by chance?

John :-#)#

--
(Please post followups or tech inquiries to the USENET newsgroup)
                      John's Jukes Ltd.
        #7 - 3979 Marine Way, Burnaby, BC, Canada V5J 5E3
          (604)872-5757 (Pinballs, Jukes, Video Games)
                      www.flippers.com
        "Old pinballers never die, they just flip out."