Sujet : Re: modifiable backplane with sockets?
De : jl (at) *nospam* glen--canyon.com (john larkin)
Groupes : sci.electronics.designDate : 30. May 2025, 19:15:36
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <6ctj3klhgvl1p4hbs6t86e8u78b84aldsh@4ax.com>
References : 1 2 3 4 5 6 7 8
User-Agent : ForteAgent/8.00.32.1272
On Fri, 30 May 2025 09:06:22 -0800, Christopher Howard
<
christopher@librehacker.com> wrote:
Christopher Howard <christopher@librehacker.com> writes:
>
- on the raised islands, is that just another layer of copper clad
laminate? Is there some special material I'm seeing underneath the
blue break-out boards? What tool do you use to cut out chunks of the
laminate?
>
Also, what glue do you use when you need to glue on pads or components?
Double-stick foam tape or 5-minute epoxy.
modifiable backplane with sockets?
Re: modifiable backplane with sockets?