Sujet : Re: modifiable backplane with sockets?
De : christopher (at) *nospam* librehacker.com (Christopher Howard)
Groupes : sci.electronics.designDate : 30. May 2025, 23:34:35
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <87a56t20ec.fsf@librehacker.com>
References : 1 2 3 4 5 6 7 8
User-Agent : Gnus/5.13 (Gnus v5.13)
I like this idea of building the modules on top of FR-4 boards. However,
this leaves me unclear on how I should interface the modules to the
backplane. The "postage stamp" idea was appealing, but I am not sure how
I would attach the pins. I know I don't want to be trying to drill very
precise holes, or to be scratching out 20 little islands on the copper.
Any further thoughts on this?
--
Christopher Howard
modifiable backplane with sockets?
Re: modifiable backplane with sockets?