In article <ASCII-20260602180622@ram.dialup.fu-berlin.de>,
Stefan Ram <ram@zedat.fu-berlin.de> wrote:
cross@spitfire.i.gajendra.net (Dan Cross) wrote or quoted:I used, "monodraw" on the Mac. I can't do that by hand; I am>
not artistically gifted. :-)
I have been searching for an ASCII-to-ASCII program for a long
time and never found anything impressive. I want to write
a /description/ of my diagram in ASCII and then want to get
my diagram as ASCII. Dot, ditaa, nothing worked.
>
The least bad solution I found so far is called /PlantUML/.
Personally, I rather like `pic` and `nroff`. Your mileage may
vary, however, depending on the complexity of the diagram.
- Dan C.
Les messages affichés proviennent d'usenet.