Liste des Groupes | Revenir à col misc |
On 1/20/25 3:58 PM, D wrote:Go to your friendly neighbourhood 3d printer! =) Wouldn't that work?On Mon, 20 Jan 2025, 186282@ud0s4.net wrote:>
On 1/20/25 5:10 AM, The Natural Philosopher wrote:This is promising!On 20/01/2025 09:30, D wrote:Used to run an external USB magnetic fromI've managed to get a P4 I think to run one spinning rust disk without extra power.The Pi hat or OMV ?The pi, with directly connected spinning disks. Does the hat have its own extra power supply?
Strictly it depends on the disk.
The pi hat for 5 drives has an external 60W PSU
a Pi4 ... worked just fine. TWO of them,
well, not so sure.
The 5-drive hat ... Philosopher says it needs
at least a 12v/5a supply, esp if you're gonna
run all magnetics. I have a couple of those
around, may have to splice on the right plug ...
Gotta whip together SOME kind of holding frame.
The Pi, hat and drives just kinda stick up there
by gravity as-is. May still have some sheets
of ABS plastic ... a little epoxy .....
>
Les messages affichés proviennent d'usenet.