Liste des Groupes | Revenir à col misc |
For SSD's, writes occur to an "erased" flash block (typically muchOne of the best ways to gain speed and longevity is to buy an SSD that is way larger than you need. So it always has empty blocks available.
larger than a "disk sector" size used by the host) and given enough
writes over a short enough timeframe the SSD controller can run out of
"pre-erased" blocks to use, and when that happens write speed slows
down to the rate that can be done when a "block erase" has to occur
before the actual writes can hit the media. Note that this "block
erase" can also invove moving any partially used data sectors out of
the block into another block, creating a "write amplification"
situation as well.
Les messages affichés proviennent d'usenet.