Re: News : ARM Trying to Buy AmperComputing

On 1/21/25 4:13 AM, D wrote:
 >
 >
 > On Mon, 20 Jan 2025, 186282@ud0s4.net wrote:
 >
 >> On 1/20/25 3:58 PM, D wrote:
 >>>
 >>>
 >>> On Mon, 20 Jan 2025, 186282@ud0s4.net wrote:
 >>>
 >>>> On 1/20/25 5:10 AM, The Natural Philosopher wrote:
 >>>>> On 20/01/2025 09:30, D wrote:
 >>>>>>>
 >>>>>>>  The Pi hat or OMV ?
 >>>>>>
 >>>>>> The pi, with directly connected spinning disks. Does the hat have its own extra power supply?
 >>>>>
 >>>>> I've managed to get a P4 I think to run one spinning rust disk without extra power.
 >>>>> Strictly it depends on the disk.
 >>>>> The pi hat for 5 drives has an external 60W PSU
 >>>>
 >>>>  Used to run an external USB magnetic from
 >>>>  a Pi4 ... worked just fine. TWO of them,
 >>>>  well, not so sure.
 >>>>
 >>>>  The 5-drive hat ... Philosopher says it needs
 >>>>  at least a 12v/5a supply, esp if you're gonna
 >>>>  run all magnetics. I have a couple of those
 >>>>  around, may have to splice on the right plug ...
 >>>
 >>> This is promising!
 >>
 >>  Gotta whip together SOME kind of holding frame.
 >>  The Pi, hat and drives just kinda stick up there
 >>  by gravity as-is. May still have some sheets
 >>  of ABS plastic ... a little epoxy .....
 >>
 >
 > Go to your friendly neighbourhood 3d printer! =) Wouldn't that work?
   Umm ... that'd be a lot more expensive than just
   cutting/gluing some raw plastic sheets  :-)
   There exists some thin 'expanded aluminum' sheets
   that are normally used on the bottom half of
   screen doors - silver or pretty gold. They are
   easy to cut and bend tight. Look around in
   a Lowes store. I've used that for make-do
   enclosures before.
https://www.lowes.com/pd/M-D-24-in-x-3-ft-Aluminum-Sheet-Metal/1000243353
   If you have one of these :
https://www.northerntool.com/products/ironton-portable-sheet-metal-bending-brake-30in-wide-101452
   then you're way ahead of the game.
   I think of a Pi as "economy" and thus keep the
   apps/add-ons kinda cheap. Otherwise I'd use some
   kind of desktop.
   Alas those cheap BeeLink/BMax units only have
   one SATA port so you can add an SSD drive in
   the bottom of the box. I think Orinco sells
   a "SATA hub" ... kinda like a USB hub ... that
   can turn one into many. Dunno if it only works
   with Winders drivers however .......