Re: News : ARM Trying to Buy AmperComputing

On Thu, 23 Jan 2025 21:59:58 +0100, D wrote:

I've seen some tutorials utilizing the GPIO pins. I imagine that that is
where it would come in handy to avoid a birds nest of cables and crappy
soldering.

I use solderless breadboards and Dupont wires when playing around. It's
quick and dirty, emphasis on the dirty part. The preformed jumpers are
neater but they're a bit of a PITA. I've seen videos of people pressing
them in with no problems but that ain't me.

I haven't done a PCB in decades and never was very good at it but that was
before software to help with the routing. There's still a lot of overhead
for a DIY project.

https://www.instructables.com/DIY-PCB-using-Liquid-Photoresist/

That's the basic procedure I followed. For one-offs I used presensitized
PCBs rather than spreading it on myself. For volume I'd make a silkscreen
but then you're into a whole other art form. The artwork was tape and
transfer symbols on mylar.

Then you move on to etching. I used ferric chloride which is fairly nasty
stuff and tends to dye everything in sight yellow. Another choice was
sodium persulfate. I never used HCL and hydrogen peroxide. That seems to
have its fans.

Then if you finally wind up with a flawless PCB the fun begins, drilling a
crap load of holes. A Dremel drill press helps. Depending on the board
material, buy a lot of bits.

All that makes the online services look extremely attractive.