Re: syslog setup

On Wed, 12 Jun 2024 14:25:44 -0400, Paul Coviello wrote:

this is what I have currently from this file
https://vmssoftware.com/docs/syslogd-openvms-04-Feb-2018.pdf:

I notice it says to be sure to use tabs, not spaces, to separate the
facility/severity spec from the destination spec. There’s even an option
to send the messages to OPCOM, too, which might be useful.

There’s an example “logger” command to send a test log message; did you
get as far as trying that?

Just guessing, here; I have zero familiarity with syslog on VMS.