Re: Dual monitors on Pi5

bp@www.zefox.net wrote:

Having some strange trouble getting dual monitors working with my
8GB Pi5. It only wants to use one of them.

After much fumbling about, both monitors are recognized and
working as desired. HDMI0 is the monitor providing audio output,
HDMI1 is a DVI monitor providing extra screen space. So far, so good.

Most of the time, HDMI1 isn't needed. However, if I power it off,
the mouse freezes, even if the cursor is visible on HDMI0. Worse
things could happen, but I'd rather not leave it powered on without
need. HDMI1 uses around 60 watts, more than the rest of my hardware
combined. I never tested this with the earlier dual-monitor setup,
a small 1600x900 DVI, so am not certain if the behavior is new or old.

Anybody know of a workaround?

Thanks for reading,

bob prohaska