Sujet : Re: Setting a manual IP address
De : knute2024 (at) *nospam* 585ranch.com (Knute Johnson)
Groupes : comp.sys.raspberry-piDate : 14. May 2024, 22:37:08
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v20li4$db68$1@dont-email.me>
References : 1 2 3
User-Agent : Mozilla Thunderbird
On 5/14/24 16:30, bp@
www.zefox.net wrote:
Knute Johnson <knute2024@585ranch.com> wrote:
>
If you have a desktop use the NetworkManager to set your static IP.
Click on the Up/Down Arrows on the -> Advanced Options -> Edit
Connections, select the wired connection you want to change and then
click the IPv4 tab and set a static IP address.
>
What is the path to NetworkManager? It's present if I run it
from the command line, but that doesn't bring up any dialogs,
it only reports that it's running and turns off WiFi 8-(
Do you have a desktop? A graphical display? NetworkManager is in the upper right corner. You open it by clicking on the up and down blue arrows. If you don't have a desktop see below:
If you don't have a desktop use nmtui from the command line. It has a
character interface similar to raspi-config. If you need further
instructions on nmtui, post again.
Nmtui seems closer to what I was looking for. Basically I need to
set a special IP, connect the bridge, log into the bridge and set
it up using a browser, then either set a static IP or use DHCP.
I think you've got me on the correct foot, thank you!
bob prohaska
-- Knute Johnson
Setting a manual IP address
Re: Setting a manual IP address
