Re: Seeking cable management ideas....

Andrew Smallshaw <andrews@sdf.org> wrote:

coil and lies flat once released.  Some cables work better than
others, in particular cables that have been abused in the past
(including in the packet!) may be less reluctant to co-operate.
 

You probably meant "less willing"?

In fact, the cables I'm dealing with are the worst of the worst.
Stiff insulation, badly kinked in the package and unwilling to
coil anywhere close to flat.

One approach that sort-of works is to plug two walwarts (one for
the Pi, one for the hub) into a single 3-outlet extension cord,
then coil the excess wire (both mains and 5-volt) around the cleat-
like object which results and hold it in place by a cable tie or
split conduit.  I've done a couple like this and it's ugly but better
than loose wires. One can at least see where each Pi plugs in.

A few wallwarts have extra connectors spliced on, such as a USB type C
together with a micro-USB or a cylinder jack. I think those might be
candidates for the plastic bag treatment, but the wallwarts shouldn't
go in the bag; they run warm and need air circulation.

I've still not figured out how to clean up the serial console and USB
cables, but that may not be so necessary as they're less voluminous.

Supporting the hubs, disks and Pis is still a problem. Broom clips sprung
open to hold the plastic Raspberry Pi cases edgewise seems to work OK,
but at this point the disks and hubs are just tucked in between, loose.

Thanks to everyone for writing!

bob prohaska