Re: an irritatingly common occurrence

On 3/24/2025 11:29 AM, AMuzi wrote:

On 3/24/2025 10:11 AM, Zen Cycle wrote:

On 3/23/2025 10:50 AM, AMuzi wrote:

On 3/22/2025 10:17 PM, zen cycle wrote:

On 3/21/2025 5:36 PM, AMuzi wrote:

On 3/21/2025 4:11 PM, Zen Cycle wrote:

Lennard Zinn describes the causes and repair process for removing
broken cables from  11sp Ultegra ST-R8000 and 6800, and various Dura-
Ace levers.
>
https://lennardzinn.substack.com/p/getting-a-broken- shift- cable-out
>
According to Lennard it's "an irritatingly common occurrence".
>
Maybe if they used special Campagnolo non-stretch shifter cables it
wouldn't be a problem?

>
Mr Zinn's right on that point.
>
Campagnolo Ergo wires stick one's palm as they start to fray, well
before failure. It's a very noticeable warning.

>
Which version/models/years are you referring to? I rode Campagnolo Chorus 9Sp for many years, never had that experience.

>
The wire path is on the outside and the capstan spools under the lever, so fraying starts at the outside bottom of your palm and although not painful it's noticeable.
>

>
Is that on the older 9sp stuff as well?
>

 Yes, all 8, 9, 10 Ergos from 1992; same wire path.
 The 11, 12, 13 speed (non rebuildable) Ergos have the same general layout but the wire path is under a cover so now a fraying wire won't stab the operator.  A broken head still falls straight down, out of the shifter, rather than mangling the mechanism as with The Other brand.
 

That's interesting, I had Chorus 9sp on my commuter and race rig for probably ten years. After I converted my race rig to 10sp I put the chorus setup on my cx bike (still there) and raced it for a number of years. I've never had an issue with fraying cables. Just luck I guess?
--
Add xx to reply