Re: Thoughts on industrial design

On 4/29/2025 4:32 AM, Roger Merriman wrote:

Frank Krygowski <frkrygow@sbcglobal.net> wrote:

>
Here in Northeast Ohio, it's difficult for a car to last that long even
if given normal good care and driven infrequently. That would have
described "the pinnacle of automotive achievement," the 1990 Honda Civic
Station Wagon that I sold when it was over 21 years old. It was a quirky
thing, fun to drive, efficient, with surprising carrying capacity. But
"rust never sleeps" as Neil Young said. I'll skip the long list of
seriously rusted bits that caused me to finally give up on the car. (But
have you ever had a car's gas tank drop due to rusted and broken support
straps?)

 I’d be surprised if Ohio is any wetter than UK? Or Germany for that matter
depending on where, my old Volvo is rust free, to the best of my knowledge
don’t get any advisory during the MOT etc.

I think the difference is salt, especially road salt, plus our large number of freeze-thaw cycles. Under Lake Erie is an immense reservoir of rock salt: https://www.cleveland.com/metro/2017/12/go_under_lake_erie_and_inside.html   and it's used liberally on winter roads. It's very corrosive.

I have never had a problem figuring where my desired gear was. It
may be because I seem to be very tolerant of gear ratios, cadences, etc.
But my three friction shifting bikes all have essentially identical
"half step" gearing, so I'm very, very used to that.
>

1 by even if not electronic is much easier system to use, with down or up
shift. And doesn’t get stuck between chainrings ie how much am I cross
chaining do I need to shift down and then up on the cassette hence my old
commute bikes 1-10 is lot more liveable with than the 3-9 which absolutely
had better range but for the commute was tedious.
 The ability to drop a lot of gears with a double is useful I find and I
like the relatively low cost of 10s stuff and the gearing range with the
GRX rear mech.

My ancient "half step" is admittedly quirky. I think the system originally arose back when derailleurs were far less capable and precise. It was a way for those old derailleurs to get reasonably close gear spacing and still have wide range available. For decades, "half step plus granny" was the most capable touring gear setup. I liked it so well I still have it on my most frequently ridden bikes.
But it is quirky! One friend of mine who was, back then, the technical guru of another bike club, claimed that it was impossible for women to understand half step gearing. (!) He'd be pilloried for saying that today.
--
- Frank Krygowski