Re: cleaning the commute bike

On Mon, 20 Jan 2025 13:14:22 +0100, Wolfgang Strobl
<news51@mystrobl.de> wrote:

Am Mon, 20 Jan 2025 06:39:30 -0500 schrieb Catrike Ryder
<Soloman@old.bikers.org>:
>

On Mon, 20 Jan 2025 08:38:18 +0100, Wolfgang Strobl
<news51@mystrobl.de> wrote:
>

Am 19 Jan 2025 14:33:37 GMT schrieb Roger Merriman <roger@sarlet.com>:
>

In slightly disappointing news I’ve discovered that the Old school roadie
commuter does need to be cleanse or shifting becomes hit and miss!
>
Unlike the old MTB who’s cables run safely out of reach of muck and grime
the roadie runs the shift cables around the bottom bracket, which collected
salt/grime which eventually stopped it shifting reliably to the big ring.

>
Wireless shifting might come to the rescue. :-)
>
I avoid these conditions nowadays, so I can't report on how the rear
derailleur deals with dirt and especially salt. Most probably not worse
than a mechanical one and perhaps better.
>
Years ago, when commuting around the year, I had both spare cable guides
and cables in my toolbox.  Using a a little bit of grease helps, but
can't help with corrosion on salted roads, in the long run. Replacing
both the inner cable and the cable guide after winter is a more reliable
solution. These parts are cheap.
>
>
<https://duckduckgo.com/?t=ffab&q=derailleur+cable+guide+bottom+bracket&iax=images&ia=images>

>
Full length housing pretty eliminates those problems, and it's easier
to install and replace.

>
Depending on the frame, it might be difficult to route the housing
through the bottom bracket.

Through the bottom bracket?  I wasn't referring to running it through
the frame. Just full length cable housing. Maybe I have the wrong
term. I think I see the housing refered to as cable guide. Our
Catrikes have no bare wire except right at the deraileurs.

--
C'est bon
Soloman