Re: Ove Interest?

On Tue, 25 Feb 2025 21:04:39 -0800, Jeff Liebermann <jeffl@cruzio.com>
wrote:

On Wed, 26 Feb 2025 11:35:33 +0700, John B. <slocombjb@gmail.com>
wrote:
>

rOn Tue, 25 Feb 2025 19:23:49 -0800, Jeff Liebermann
<jeffl@cruzio.com> wrote:
>

On Tue, 25 Feb 2025 18:29:29 GMT, cyclintom <cyclintom@yahoo.com>
wrote:
>

Why do you suppose that Liebermann would take your comments and distort thgem to mean that one should use marine bottom paint to protect dry steel bike frames?

>
Please show me where I suggested the use of marine paints for painting
bicycle frames.  Hint:  I made no such suggestion.  Here is an exact
quote for what I'm trying to do. 
>

Change-o-topic:
Has anyone actually tried using an rust prevention concoction such as
lanolin (sheep oil) based Fluid Film for preventing rust and
corrosion?
<https://www.fluid-film.com>
<https://www.fluid-film.com/products/>
<https://www.fluid-film.com/recreation-applications/>
If so, which version and did it work?

>
Andrew suggesting trying linseed oil and John B suggested marine
paints.  If you look back at the comments prior to yours, none of them
had anything to do with bicycles.  See:
Message-ID: <orbarj9866m4c0ro9l0smcaq9fg8bu0cj0@4ax.com>  (Jeff L)
Message-ID: <vp3dlo$1v2d6$3@dont-email.me>  (Andrew)
Message-ID: <6itcrj5gh3hrl7mku90h2bsajeo2vgfs0d@4ax.com>  (John B)
>

The problem with marine paints is that they do not have a good  inish that you want on a bike. If you want a good bicycle finish you can use two part epoxy paint but you must immediately then clean out the sprayer with acytone. Another method is to take your frame to a powder coating company and have the old frame and fork sand blasted clean and you then spray and cook on a powder coating. The are also available in high luster finishes. Though those are quite a bit more expensive. Semi-shiny white finishes are commony used on shop shelves and is quite inexpensive and is difficult to rust through.

>
Oh! I thought you7 wee painting showers (to take a bath)

>
Yes.  I wanted to find a general purpose rust prevention spray that
would work with almost anything.  Something like WD-40 except
optimized for rust protection and probably conversion to iron
phosphate.  For my shower, the plan was to use Fluid Film (lanolin) as
temporary protection until I do something more permanent with the
shower.

You seem to have a lot of "rust" problems... far more than I can
remember having in a series of tropical countries. I don't remember
ever  have as many problems as you seem to have. But we always sprayed
(power tools any way) with an anti rust spray every once in a while..





--
Cheers,

John B.