Sujet : Re: Machine Shop
De : frkrygow (at) *nospam* sbcglobal.net (Frank Krygowski)
Groupes : rec.bicycles.techDate : 05. Mar 2025, 17:43:43
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vq9v00$2g05k$3@dont-email.me>
References : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
User-Agent : Mozilla Thunderbird
On 3/5/2025 12:50 AM, AMuzi wrote:
On 3/4/2025 10:04 PM, Frank Krygowski wrote:
On 3/4/2025 3:06 PM, AMuzi wrote:
Here's one set of steel blocks for rolling dents.
>
http://www.yellowjersey.org/photosfromthepast/den24a.jpg
>
So how exactly are the blocks used? Are the blocks tightened in place and rotated around the tube?
>
>
Hold lower block in a vise. Lay tube in the block, add plenty of gear oil, place top half of block on the tube, tighten the bolts gradually while working the tube back and forth between the two block halves. Once bolts are fully tightened, remove tube, clean and fill remainder of dent.
Got it, thanks.
-- - Frank Krygowski
Re: Machine Shop
Re: Machine Shop
