Re: RE: Re: Disc Compatibility?

On 3/6/2025 11:57 AM, cyclintom wrote:

On Thu Mar 6 06:04:53 2025 zen cycle  wrote:

On 3/5/2025 2:17 PM, cyclintom wrote:

On Tue Mar 4 21:55:28 2025 Roger Merriman wrote:

cyclintom <cyclintom@yahoo.com> wrote:

Andrew, I have GRX levers and Ultegra actuators. It acts as if
these are
not compatible. The levers on both front and rear will not "pump" the
brake pades close enough to the discs so that they actuate with
almost no
pull. Instead they pull almost all of the way to the bar.
>
The pads are hardly worn and there are no leaks from the connections.
>

Should be, uses same pads/hose fitting kit and so on, and appears to be
same calipers broadly from Tiagra to Dura Ace, though Cues is I believe
doing its own thing! Aka less performance more simple design.

>
>
>
>
What I was trying to discover was if the 10 speed GRX levers didn't
have the capacity of the 11 speed Ultegra actuators. That occurred to
me in a dream.

>
Which is where tommy gets most of his silly ideas - dents popping out of
top tubes, for example
>

But since they are compatible it must be air in the

system. The thing that bothers me is that all of my previous disk
bikes had hard front and back brakes. This setup has the same pull on
front and back and the front is a straight shot up and bled without a
problem.

>
Because the rear caliper line entry is at an unusual angle. The front
points straight up.
>
Need to remove the rear caliper form the frame so it can be at the
lowest point in the system, line pointing up. Rap the caliper with a
tool handle while purging the fluid. It has air in the nooks and
crannies of the caliper.

    You are very effective at saying "duhhhhh".

Not nearly as effective as "mr. light lines".

When are you going toi tell us that you have a PhD in metalurgy?

About the same time I tell you I rode 200 miles in one day.
--
Add xx to reply