Re: Garmin

On 5/30/2025 1:46 PM, Roger Merriman wrote:

cyclintom <cyclintom@yahoo.com> wrote:

On Thu May 29 10:51:29 2025 Roger Merriman  wrote:

cyclintom <cyclintom@yahoo.com> wrote:

I got a Garmin Edge 1030+ for $250 and he mailed it for free. It stores
previoue rides in the computer itself and you should have seen the rides!
50+mile rides were common and were fast. every week or so the lady, who
weighed only 140 lbs did a 25 mile ride no doubt to measure FTP. The
longest ride I noticed was 75 miles. There were over 2 years of rides so
it took m3 a couple of hours to clean all of the rikdes and courses out
of it and it will be starting with a clean slate. every sensor but my
heart rate monitor had dead batteries on the Time Ulteam. So I replaced
the batteries and matched them to the 1030+. I will use the 830 on the
DeRosa Idol. I sold the Colnago Dream so I psid off my bills.
>

>
You can factory reset and wipe all data takes maybe a few minutes mainly
waiting for it to reboot.
>
Please tell me you didn?t go individually through deleting each
ride/course!
>
Why are you using both units? You can have different profiles on the Garmin
for each bike and so on.
>

I am going to have to rebuild the Ridley Helium since it has been 5 years
since I rode it and the reach was altogether too long now. I will sell
the integrated bar.
>
Andrew, the Di2 levers look like they that three wire inputs and two of
them have plugs in them. Can I go in one ang out the other to the other
lever? Since I'm using an aluminum bar I will drill a small hole next to
each lever and route the wires inside the bars. I can use a shorter stem
and move the saddle getting rid of two inches reach.

>
>
>
>
But then I have to reset the sensors every time I change bikes. I am
installing 32 mm tires on the disc bike and from the look of it I think I
may be able to do so also on the Time. This will give me a lot more
cussion on the local roads.

 Most people have one Garmin and multiple bikes which may well have multiple
sensors, I personally don’t as I’m more navigation inclined than
performance.

How is it this idiot doesn't know both the 830 and 1030 can support up to 30 sensors?
https://support.garmin.com/en-US/?faq=RpX8SeCLBd2K8sggJk4L56

I wasn't sure without a manual exactly what the reset did so I manually reset everything.

 It’s extremely simple no manual needed.

Not only that, the manual is available on line.
How the hell does kunich manage to wipe his own ass?