Re: Air pistol update

Liste des GroupesRevenir à rc metalworking 
Sujet : Re: Air pistol update
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworking
Date : 17. May 2025, 17:27:13
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <100add0$f9kt$1@dont-email.me>
References : 1
User-Agent : Mozilla Thunderbird
On 5/16/2025 12:12 PM, Snag wrote:
   I decided I'd replace the pump first , make sure the rest of the pistol functioned . It does , but I can hear air leaking thru the reservoir seal when I pump it . I did manage to get a couple of shots off before the seal failed , and I think it's worth a few more bucks to replace all the seals .
   With today's seal kit purchase I'm now into this project a total of just over 33 bucks . I may decide to replace the barrel too depending on how accurate it is once I get the seals replaced .
Unless somebody has been shooting steel BBs through the barrel its likely (sans lead fouling) as good as it was when it was new.  Lead pellets are typically dead soft lead.  They are not hardcast like pistol projectiles.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com

Date Sujet#  Auteur
16 May 25 * Air pistol update7Snag
17 May 25 `* Re: Air pistol update6Bob La Londe
17 May 25  `* Re: Air pistol update5Leon Fisk
17 May 25   `* Re: Air pistol update4Snag
17 May 25    `* Re: Air pistol update3Leon Fisk
17 May 25     `* Re: Air pistol update2Leon Fisk
17 May 25      `- Re: Air pistol update1Snag

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal