Re: Nothing Special For You Guys, but it is metalworking

On 5/25/2025 2:40 PM, Snag wrote:

On 5/25/2025 3:30 PM, Bob La Londe wrote:

Quick Easy Vise Hold Down Clamps (video)
https://rumble.com/v6tv2qr-quick-easy-vise-hold-down-clamp.html? mref=1sqt4y&mc=42lue
>
>

 Now I want to make a set for my screwless vise . It's not as big as yours ... I considered thinning the noses of a couple of my clamp bars but this is much more elegant .
   Gotta finish the gas check punch set first . Started one of mild steel but decided to use O1 instead . Because I remembered I have some .

I have a bunch of those imports screwless vises.  I kind of think of them as consumables, but they do cost a lot more than they used to.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com