Re: Pin material ?

On 6/8/2025 5:05 PM, Clare Snyder wrote:

On Sun, 8 Jun 2025 16:04:09 -0500, Snag <Snag_one@msn.com> wrote:
 

   I managed to lose one of the pins that hold the lift link clevis to
the lower arms on my "new" tractor - adjustment turnbuckle was froze up
from several years sitting out in the woods . I made one from some mystery steel I have on hand but I got to wondering if I should have
used some of the 4140 I have on hand or maybe case hardened it . The
4140 is larger diameter , so more waste . I hate wasting material if I
don't have to . For all I know the piece I used is alloy , but it isn't
marked . I usually mark bought material but found or gifted stock I
don't always know what I've got so ...

  I use grade 5 or grade 8 bolts as feed stock, depending on required
strength and hardness. - or even grade 3 if that is all that is
required. I go by the head markings to know what I have - - -
 

   This didn't start out as a bolt , it's from  a 1" piece of round stock. Bolts are way too expensive to use as lathe stock .
--
Snag
We live in a time where intelligent people
are being silenced so that
stupid people won't be offended.