Sujet : Re: Precision ?
De : lfiskgr (at) *nospam* gmail.invalid (Leon Fisk)
Groupes : rec.crafts.metalworkingDate : 21. Jun 2025, 21:29:46
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <10374nq$17686$2@dont-email.me>
References : 1 2 3
User-Agent : Claws Mail 4.3.1 (GTK 3.24.38; x86_64-pc-linux-gnu)
On Sat, 21 Jun 2025 14:25:09 -0500
Snag <
Snag_one@msn.com> wrote:
<snip>
No , you didn't ... a bit late now since I've fitted the drive
coupler to a larger crankshaft but I will check that . If I can figure
it out I'll keep this motor for a replacement for the tiller . The new
motor was originally intended for the tiller , but it recovered from
it's problem and has been running fine .
It's a long shot, I know you do good work👍️
I felt like an idiot when I found that mud nest clogging the exhaust
after having the carb all apart among other things🙄️
One other odd thing I've seen is a partially sheared half-moon key on
the crank shaft to flywheel. May happen after a particularly violent
stall-out type mishap or the flywheel bolt has loosened a tad. It threw
the timing off just enough that it would still run but poorly.
-- Leon FiskGrand Rapids MI
Precision ?
Re: Precision ?