Liste des Groupes | Revenir à rc metalworking |
On 7/15/2024 12:30 PM, Richard Smith wrote:Hello allI have an oil can that I use on the lathe and the mill. Made of a tuna
Ideas for smallish oil-can which can be in a toolbox?
- mustn't leak all over
- smallish and light
- can deliver a few drips of oil down air-tool inlet
Thinking of those "popper" oil-cans - small disks. But how to seal
stem / spout?
Ideas?
Regards,
Rich Smith
can with the lid soldered back on. It has a hole drilled in the center
big enough to allow a small hobby brush to reach the bottom of the
can. Soldered into the hole is a small piece of copper tube long
enough to penetrate to about half way into the can. The tube protrudes
about a half inch above the surface of the lid. If the can is filled
only to about 3/8 of total depth, it will not leak all over if
upended. The brush would be able to dispense a drop or two into an air
tool.
YMMV
>
Steve
Date | Sujet | # | Auteur | |
15 Jul 24 | oil-can for toolbox for air-tool oil | 11 | Richard Smith | |
15 Jul 24 | Re: oil-can for toolbox for air-tool oil | 1 | Leon Fisk | |
15 Jul 24 | Re: oil-can for toolbox for air-tool oil | 1 | Bob La Londe | |
15 Jul 24 | Re: oil-can for toolbox for air-tool oil | 1 | Jim Wilkins | |
16 Jul 24 | Re: oil-can for toolbox for air-tool oil | 5 | shiggins | |
17 Jul 24 | Re: oil-can for toolbox for air-tool oil | 2 | Gerry | |
17 Jul 24 | Re: oil-can for toolbox for air-tool oil | 1 | Jim Wilkins | |
17 Jul 24 | Re: oil-can for toolbox for air-tool oil | 2 | Richard Smith | |
17 Jul 24 | Re: oil-can for toolbox for air-tool oil | 1 | Jim Wilkins | |
18 Jul 24 | Re: oil-can for toolbox for air-tool oil | 2 | Bob La Londe | |
18 Jul 24 | Re: oil-can for toolbox for air-tool oil | 1 | Jim Wilkins |
Les messages affichés proviennent d'usenet.