Sujet : Re: Gauge blocks
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 28. Jun 2024, 03:01:36
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v5l5i0$34grl$1@dont-email.me>
References : 1 2 3 4
User-Agent : Mozilla Thunderbird
On 6/27/2024 5:59 PM, Jim Wilkins wrote:
"Snag" wrote in message news:v5kuvs$2vope$1@dont-email.me...
I could have done this without them , but I never let an opportunity
to buy tooling go to waste .
---------------------------
I rarely pass up on measuring equipment, especially second hand. And sometimes, years later, I really do need it, like a Mitutoyo 146-102 Groove Micrometer I got cheap from a seller who didn't know what it was, and I needed a week or two ago. IIRC I was the only bidder on the gauge block set with a couple of common sizes missing. MSC had them for ~$16 each, accurate to better than 10 microinches.
I have a Starrett can lid micrometer. Never know when I might need it. I could wind up at Libbey chopping green beans and sealing lids. LOL.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com