Re: Inside micrometer

Liste des GroupesRevenir à rc metalworking 
Sujet : Re: Inside micrometer
De : Snag_one (at) *nospam* msn.com (Snag)
Groupes : rec.crafts.metalworking
Date : 08. Jul 2024, 19:08:43
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v6h9ve$vl20$1@dont-email.me>
References : 1
User-Agent : Mozilla/5.0 (Windows NT 6.1; WOW64; rv:60.0) Gecko/20100101 Thunderbird/60.9.1
On 7/8/2024 12:41 PM, Snag wrote:
   I scored an older unit complete with all the rods ...but they are not set correctly . The 1.5-2.5" is off by about .009" short of 1.5 when the thimble is zeroed . Looking into the end that goes into the head I see a setscrew . I think this is used to set the rod length but I want to be sure of procedure before I go reefing on it . The other question I have is about the "extended" setting . The head only has .500 of travel and there are 2 setscrew dimples in the mounting sleeves . When in the "long" dimple it's about .050" short .  I suspect there must have been a .500 sleeve that set the proper length in the long position . Any help will be appreciated !
   I guess I should have mentioned this is the Sherr-Tumico unit I posted about last week .
--
Snag
  White lives matter too .

Date Sujet#  Auteur
8 Jul 24 * Inside micrometer5Snag
8 Jul 24 `* Re: Inside micrometer4Snag
9 Jul 24  `* Re: Inside micrometer3Bob La Londe
9 Jul 24   `* Re: Inside micrometer2Snag
9 Jul 24    `- Re: Inside micrometer1Bob La Londe

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal