Sujet : Re: Tapered Pins
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 20. Jul 2024, 23:27:21
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v7hdk9$3no6e$1@dont-email.me>
References : 1 2 3
User-Agent : Mozilla Thunderbird
On 7/20/2024 9:00 AM, pyotr filipivich wrote:
"Jim Wilkins" <muratlanne@gmail.com> on Fri, 19 Jul 2024 20:46:02
-0400 typed in rec.crafts.metalworking the following:
>
South Bend used taper pins on my lathe, some of which didn't survive the
students' abuse. I acquired some spare parts which had been drilled
differently for the taper pins. It seemed to me the idea was to ream by
hand, tap in the pin and then cut off the excess.
I still have a batch of brass taper pins made for the class
machines. Brass shears off and protects the machine - at leas that is
the theory
The thing is there really isn't any point to having stock size taper pins available more than minimally longer than you can ream. I was excited to see a couple pins available that might fit my application only to find I would have to create my own tool to ream the holes. I can make my own tools, but it takes a lot of time.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Tapered Pins
Re: Tapered Pins