Sujet : Re: Silly Setup
De : Snag_one (at) *nospam* msn.com (Snag)
Groupes : rec.crafts.metalworkingDate : 24. Aug 2024, 19:08:58
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vad7j4$1g23f$1@dont-email.me>
References : 1 2
User-Agent : Mozilla/5.0 (Windows NT 6.1; WOW64; rv:60.0) Gecko/20100101 Thunderbird/60.9.1
On 8/24/2024 12:04 PM, Bob La Londe wrote:
On 8/24/2024 10:00 AM, Bob La Londe wrote:
Silly setup, but it worked.
>
https://www.yumabassman.com/wp-content/uploads/2024/08/Setup.jpg
>
Something like this ER11 R8 collet chuck might have been better,
https://www.yumabassman.com/wp-content/uploads/2024/08/ER11-R8.webp
but the crazy setup did work. In fact this is the third time I have made a mold using this setup with cross pins.
I actually have an R8-ER16, but the collet nut didn't give me enough clearance to do the job.
My current silly setup is a 1/2" piece of steel plate bolted to a faceplate . It will be a fixture to hold a connecting rod so I can use the lathe and my dremel fixture to open up the wrist pin hole . This is part of the Arctic Cat 600 to 660 performance upgrade . That boy is gonna kill himself ...
-- Snag Illegitimi non carborundum
Silly Setup
Re: Silly Setup