Re: flameless heat !

On 9/10/2024 2:02 PM, Mike Spencer wrote:

Bob La Londe <none@none.com99> writes:
 

Ah-yup.  I once decided to use a torch to make some bolt holes for a
frame mounted receiver hitch on an old beater truck.  I clamped the
hitch in place and used the bolt holes as torch guides.  Imagine my
surprise when I blew through a fuel line on the opposite side of a
member and flaming gas poured out.  One of the few times I was happy to
be working on a truck laying on the ground in the middle of 100,000
square miles of kitty litter.  A couple handfuls of sand put out the
fire, and all that really poured out was what was in the line.

 Your Darwin Award is being withheld pending further review. :-)
 

I was a wild and crazy guy and not in a Steve Martin kind of way.  Dying in an inferno of gasoline was low risk for me back then.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com