Re: FINISHED IT UP WITH A GRINDER - Using A Lathe To Install a Goose Neck Hitch

On 10/16/2024 8:44 PM, Jim Wilkins wrote:

"Bob La Londe"  wrote in message news:vepf95$2e45q$1@dont-email.me...
 Finished it up with a grinder.  Many years ago, when this group was
thick with masters of all, I was a bit taken aback by all the folks who
would say, "I just freehand sharpen drills with a grinder."  Well, now I
just sharpen drills with a grinder.  Today I had to drill four holes in
the bed of the new truck for spring loaded chain loops.  The only 11/16
drill bit I found looked like it had a poor shallow grind for wallowing
its way through steel truck frames... In fact I think that's what it was
last use for, and I'm sure I was the one who put that grind on it.  I
walked it over to the grinder and put a sharp aggressive three facet
grind (6 if you want to be technical) on it for aluminum and punched the
holes I needed right through the stiffener and bed of the truck.  (There
were already holes in the steel under bed goose neck ball hitch plate.
 After that it was just the usual fat guy trying to work under a truck to
get the springs and nuts on the under side of the chain loops.
 All finished up.  Next project electric running boards so my wife can
get in and out of the truck safely without my having to run around the
truck with a step stool.  Yeah, I keep a step stool in the bed right now.
 I keep telling myself I'll get some nice CBN wheels for one of the
grinders so I can sharpen lathe bits, drills, and even split points all
on one machine and I still haven't completely worn out a set of the
cheap grey stones they come with.  I probably should dress them more
often though.
 Anyway now, "I just free hand sharpen drills on the grinder."  Its not
even very hard once you've done a few.  3/16 and up is pretty easy.  I
have sharpened smaller by swinging a magnifying lamp over the grinder,
but the smaller drills are so cheap I just buy them in batches.
Bob La Londe
 -------------------------------
 You'll know you are Really good when they drill to size. I can make a dull or broken bit cut well but usually pass it through a Drill Doctor afterwards.
 

   I'm happy if both flutes actually cut on a freehand grind . My DD only has a collet for up to 1/2" so ...
--
Snag
Voting for Kamabla after Biden
is like changing your shirt because
you shit your pants .