Re: Struck Coin Blanks ???

On 11/28/2024 12:40 AM, Peter Fairbrother wrote:

On 27/11/2024 20:57, Bob La Londe wrote:

Every since watching a woman dressed in pirate garb at a renaissance fair (or faire if you prefer) place a blank in a set of dies and drop a heavy weight on it to strike a souvenir coin I have had in the back of my mind the idea to strike my own coins.  I can certainly make the dies.   4140 is relatively easy to machine if you know how, and it will harden "hard enough" for a low production number of from a few hundred to a couple thousand coins.  I also keep a bit of O1 and W1 on hand for those cutting tools I can't hand grind from HSS or carbide.  I even have a propane forge in the back along with a toaster oven for tempering (although it gets used more for powder coating).
>
I started writing with two questions in mind.
>
Where to buy/make coin blanks at the best price?  Not the 10-20 on Ebay or Amazon, but a couple hundred to a couple thousand at a more reasonable bulk price.

 Ouch, At those prices it would be cheaper to use real money...
 Peter Fairbrother
 

... and at those prices almost exclusively shipped from China.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com