Sujet : Re: adjustable square for SHS / box sections
De : muratlanne (at) *nospam* gmail.com (Jim Wilkins)
Groupes : rec.crafts.metalworkingDate : 11. Feb 2025, 16:40:03
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vofr37$1r7ou$1@dont-email.me>
References : 1 2 3 4 5 6
User-Agent : Microsoft Windows Live Mail 16.4.3505.912
"Richard Smith" wrote in message
news:m1wmdxuep7.fsf@void.com... The "angle-aluminum" with its "drop-down" from the "top" surface marks
down from that top surface. This is a longitudinal mark. It will
always "match-up" (?).
I am painfully aware that these best-meant descriptions, where you'd
want a sketch, can be impenetrable.
Best wishes,
-------------------------------------
Similar to the miter guide for a table saw.
adjustable square for SHS / box sections
Re: adjustable square for SHS / box sections