Re: 3/8" drill chuck replacement

On 4/8/2025 5:48 PM, bp@www.zefox.net wrote:

I finally lost the chuck key to a Makita 907d cordless drill.
The chuck has never been very good at holding bits, so rather
than buy a new key I'm thinking to get a new, keyless chuck.
 Does anybody have a favorite, or suggestions to avoid? It's
a normal 3/8-24 right hand female thread, so that's easy. The
original chuck is Jacobs, are there better brands out there?
 Thanks for reading,
 bob prohaska
 

I have a bunch of chucks (mostly imports), but its surprising to hear you didn't have like the Jacob's.  Usually genuine Jacob's chucks are quite good.  I wonder if Makita licensed the name.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com