Re: make - forge? - wedge for feathers-and-wedge rock-split

"Richard Smith"  wrote in message news:m1wmp7v7i7.fsf@void.com...
"Jim Wilkins" <muratlanne@gmail.com> writes:

"Richard Smith"  wrote in message news:m1jzl89nyu.fsf@void.com... But
then yes how to get the adherent slurry out of the drilled
sockets...
>
-------------------------
>
https://www.bbqboxuk.com/products/2-piece-turkey-baster-set With an
extension hose, cut diagonally on the pickup end.

Thanks - I was trying to get ideas for this.
---------------------------
The clear ones appear to be styrene, gasoline attacks them and they can crack if abused. The somewhat frosted ones may be polyethylene or polypropylene which is more durable and chemical resistant. A reinforcing swelling at the tip helps retain the extension tubing. If too small, vinyl tubing can be expanded by warming and stretching with needle-nose pliers.
Snag-free tubing clamping:
https://www.netknots.com/rope_knots/common-whipping
The cut ends can be pushed in to disappear. I suspect the Gordian Knot used the same trick.