Re: Airing Down

"Snag"  wrote in message news:v3lfv6$2tgh$1@dont-email.me...
On 6/3/2024 4:46 PM, Jim Wilkins wrote:

>
I mentioned converting a pull ring pressure relief to a cam handle. The cam lever is a sheet aluminum rectangle bent into a channel over stock a little thicker than the valve stem diameter, and mostly filed to a rounded cam profile to lift the valve and hold it open.
>

   This is the kind of stuff that made the USA great !
--
Snag
  It's great to be straight !
------------------------------------------
I feel like I'm doing the sort of manual metalwork that might make Pakistan great.