Sujet : Re: Big Caliper
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 16. Jun 2024, 02:37:45
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v4lfl8$3reqg$1@dont-email.me>
References : 1 2
User-Agent : Mozilla Thunderbird
On 6/15/2024 6:16 PM, Jim Wilkins wrote:
"Bob La Londe" wrote in message news:v4l1bu$3l339$1@dont-email.me...
I've got a 12" and a 24" dial caliper. Off brands, well not Starrett or Mitutoyo anyway. Mostly I use them for roughing in larger mold blanks to length. Once in a while I wish I had something longer. I can use the mill as a measuring tool, and I can use gage blocks and 123/246 blocks to block up the end of a part, but what I really want is a half decent (or doesn't totally suck) 36 inch caliper. Its much faster than cranking the mill table back and forth or setting up blocking to measure with a smaller tool.
Well, I guess I'll want in one hand and save pennies in the other...
Bob La Londe
--------------------------------
https://www.wttool.com/caliper-extender-attachment-23843?gad_source=1
Oh, heck. I could make that, and pretty quick too. Or atleast a version of it.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Big Caliper
Re: Big Caliper