Sujet : Re: Hinge Rivets
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 18. Jun 2024, 20:35:29
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v4sni1$1gisb$1@dont-email.me>
References : 1 2 3 4 5 6
User-Agent : Mozilla Thunderbird
On 6/18/2024 11:54 AM, Jim Wilkins wrote:
In industry I've headed rivets on a drill press equipped with a Grant Twin-Spin tool.
I've headed a rivet with a hammer once or twice. Once you get over the initial trepidation its not to hard.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Hinge Rivets
Re: Hinge Rivets