Re: I "SNAG"ed A Couple Tool Boxes Yesterday

On 6/18/2024 12:03 PM, Jim Wilkins wrote:

"Bob La Londe"  wrote in message news:v4siak$1f893$1@dont-email.me...
 I plan to use this set just for gunsmith only tools, cleaning supplies,
and parts.  It will clean out several drawers and a couple square feet
of surface on my front office work bench.  I may put some reloading
supplies and a couple presses in it as well if the bottom drawers are
deep enough.  Well, until I get the file cabinets out of the file room,
and get a proper work bench built in that room.
 Bob La Londe
 ---------------------------
 Do you know a good non-fouling target load for a "BP-only" 45-70 Sharps or original Trapdoor?
 

Triple 7 is about as good as there is.  Its very marginally more powerful than PB, but a spacer of some kind to fill the case will work just fine.  In cap and ball you just drop the powder load a little and work up to what you want.
I've heard good things about Blackhorn 209, but its a lot more expensive, and some states will not accept it as a BP substitute for BP only hunts.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com