Re: I "SNAG"ed A Couple Tool Boxes Yesterday

On 6/18/2024 2:39 PM, Bob La Londe wrote:

On 6/18/2024 12:03 PM, Jim Wilkins wrote:

"Bob La Londe"  wrote in message news:v4siak$1f893$1@dont-email.me...
>
I plan to use this set just for gunsmith only tools, cleaning supplies,
and parts.  It will clean out several drawers and a couple square feet
of surface on my front office work bench.  I may put some reloading
supplies and a couple presses in it as well if the bottom drawers are
deep enough.  Well, until I get the file cabinets out of the file room,
and get a proper work bench built in that room.
>
Bob La Londe
>
---------------------------
>
Do you know a good non-fouling target load for a "BP-only" 45-70 Sharps or original Trapdoor?
>

 I do have a BP loading manual somewhere that I can use to look up some loads if you like, but you may be more comfortable buying your own copy than taking the word of "some guy on the Internet."
 

   Hodgdons has a BP loading chart on their website . I don't know if it covers BP metallic cartridges though . I was looking for load data for 1860 Remington reproduction cap-n-ball revolvers .
--
Snag
  It's great to be straight !