Re: Dirty Hands Clean Money

"Bob La Londe"  wrote in message news:v6f3f0$gm1m$1@dont-email.me...
On 7/7/2024 12:43 PM, Jim Wilkins wrote:

Nice 6-jaw without visible runout, what kind?

It is a Shars "Set-Tru" style.  I like it better than the Bison 4 jaw.
It does have some run-out depending on the size of the stock.  Its only
near zero at whatever stock size you dialed it in at.  I think I last
zeroed at with a 3/4 gage pin.  Gets me within "about 3-4 tenths
(0.0003-0.0004) when its running the size stock its zeroed to.  The
spindle nose only seems to be ground to about .0003 so that's not
horrible.
It wasn't crazy expensive, but it wasn't cheap import cheap either.  I
think it was around $800-900 (+/-) with the D1-5 back plate.
I'd probably change chucks more often if they weren't so heavy and
awkward.  I have an electric chair lift I have been thinking about
converting into a bench crane for that.  I don't think I have a 12V
power supply on the shelf big enough for it though.
Bob La Londe
-----------------------------------------
A 12VDC supply that can be set to 13.6V and won't fry if connected to a discharged battery could float charge an AGM that can deliver enough current to operate the hoist.
The power bricks that came with my 12DC refrigerators were set too high for a battery and overheated when connected to a discharged one so I added these to limit the output voltage and current. :
https://www.amazon.com/DROK-Converter-5-3V-32V-Regulator-Transformer/dp/B078Q1624B/
A 1/4 ton lever chain hoist isn't that expensive and has better fine height adjustment than an electric hoist. Mine gets quite a bit of use, there's a lot around the house within its capacity and it needs minimal overhead clearance. Right now it's on an A frame to stack cut beams and slabs.
I made a wood block to hold my heaviest chuck slightly below spindle height to install or remove it. Rectangular strips of wood below and above can align it without the trouble of copying the ways and chuck.