Sujet : Re: I Quit
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 11. Jul 2024, 20:58:04
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v6pdgc$2k09f$1@dont-email.me>
References : 1 2 3
User-Agent : Mozilla Thunderbird
On 7/11/2024 3:40 AM, Jim Wilkins wrote:
"Bob La Londe" wrote in message news:v6n6c2$2469n$1@dont-email.me...
I got the new 7.5HP motor installed on the IR compressor today. The
pulley hub for the larger motor shaft and the motor both arrived
yesterday. Wow! Yeah I think it should have always had a 7.5HP motor
on it. After installation I vented the tank until the motor kicked on,
and it filled fast. Faster than the original motor with the same
pulley. The compressor must have been dragging down the 5HP motors a
little bit all along. I'm still bring the compressor from my dad's shop
and setting the two of them up together so I can quickly swap
compressors, but this is so much better I no longer feel the urge to
hurry.
Bob La Londe
----------------------------------
Congrats, another problem successfully solved.
My 80 gallon compressor is in a corner of my crowded shop and needs to be muscled out to work on it. A wider wooden base that lets it slide rather than tip helps a lot. I don't have a pallet jack or room to use one, but if I did a small pallet might be a good base for it.
The sad part is if they had used a 7.5HP motor to begin with and priced it accordingly it would have been an actual good deal, instead of a fake good deal.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
I Quit
Re: I Quit