Sujet : Re: Geometric Self Opening Die Heads
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 14. Jul 2024, 18:36:47
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v712be$8a9m$1@dont-email.me>
References : 1 2
User-Agent : Mozilla Thunderbird
On 7/13/2024 2:13 PM, Jim Wilkins wrote:
"Bob La Londe" wrote in message news:v6uh55$3mnvk$1@dont-email.me...
Geometric Self Opening Die Heads
...
I am sure if I look around I can find a used version of this tool for less than a brand new one, but I need to ask. Have you used a tool like this. The self opening die head, not a turret lathe. I am sure lots of you have used a turret lathe. How easy was it to setup for each job? How affordable where the thread jaws? Did you find it worked reliably? Do you have nay other feedback for using one or reasons not to?
Bob La Londe
-----------------------------------
https://pounceatron.dreamhosters.com/docs/geometric-die-heads.pdf
Great manual. Thanks.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Geometric Self Opening Die Heads
Re: Geometric Self Opening Die Heads
