Sujet : Re: oil-can for toolbox for air-tool oil
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 15. Jul 2024, 21:01:19
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v73v6e$rd63$1@dont-email.me>
References : 1
User-Agent : Mozilla Thunderbird
On 7/15/2024 10:30 AM, Richard Smith wrote:
Hello all
Ideas for smallish oil-can which can be in a toolbox?
- mustn't leak all over
- smallish and light
- can deliver a few drips of oil down air-tool inlet
Thinking of those "popper" oil-cans - small disks. But how to seal
stem / spout?
Ideas?
Regards,
Rich Smith
Plastic bottle with needle tip cap. Good place in tool box to store it where it will not get squished. Small so if it still gets squished the mess is not huge. Most have gasket in cap, and cap on needle.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
oil-can for toolbox for air-tool oil
Re: oil-can for toolbox for air-tool oil
