Sujet : Re: Geometric Self Opening Die Heads
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 16. Jul 2024, 22:09:01
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v76nhd$1ee1n$1@dont-email.me>
References : 1 2 3
User-Agent : Mozilla Thunderbird
On 7/14/2024 10:39 AM, Bob La Londe wrote:
On 7/14/2024 4:04 AM, Jim Wilkins wrote:
"Bob La Londe" wrote in message news:v6uh55$3mnvk$1@dont-email.me...
Geometric Self Opening Die Heads
...
How affordable where the thread jaws? ...
>
https://www.travers.com/category/chasers
https://www.wttool.com/516-d-regular-high-speed-chasers
Ah... the cost of the "chasers" is really what I was wondering about. Thanks. I probably wouldn't buy a new die head at this point, but it would be nice to have a couple sets of dies "chasers" if I decide its worth the trouble to integrate into a process.
It looks like they are just referenced by slot size. I wonder how interchangeable they are.
Looks like I may have been wrong. They appear to be referenced by maximum thread size.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Geometric Self Opening Die Heads
Re: Geometric Self Opening Die Heads
