Tapered Pins

... of course I can make my own but for a one off project, but for a repeat stock job I would like to buy them premade.
I'm cutting a mold for somebody that casts a body with a through hole. There are nominal dimensions, but a tapered pin that knocks out easily would be acceptable.  I can buy "standard" tapered pins and "standard" tapered reamers, but when I was trying to spec it out it seems the pins are available in sizes ranging down much smaller than the small end of the reamer.  Or in other words, "WHAT?!?"
I went ahead and bought a couple sizes of pins that would be suitable for the casting, and a 0-10 set of tapered reamers.  I don't know how its going to work out, but I figure if worse comes to worse maybe I can make a tapered D-Bit reamer that actually matches the pins.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com