Sujet : Re: Tapered Pins
De : muratlanne (at) *nospam* gmail.com (Jim Wilkins)
Groupes : rec.crafts.metalworkingDate : 23. Jul 2024, 21:28:56
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v7p3rr$1bra5$1@dont-email.me>
References : 1 2 3 4 5 6 7
User-Agent : Microsoft Windows Live Mail 16.4.3505.912
"Bob La Londe" wrote in message
news:v7oucg$1ajjv$1@dont-email.me...On 7/23/2024 6:15 AM, Jim Wilkins wrote:
...
***
I'm cutting a mold for somebody that casts a body with a through hole.
There are nominal dimensions, but a tapered pin that knocks out easily
would be acceptable.
***
I may not have done an adequate job of describing the application. The
taper pin is not for "joining" or "aligning." Its to be used as a
removable core.
---------------------
Thanks. I have to assume normal use unless otherwise specified. I enjoyed the problem solving of custom machine design, repurposing what was available to new uses.