Sujet : Re: Silly Setup
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 26. Aug 2024, 00:33:11
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vagevo$24td6$2@dont-email.me>
References : 1 2
User-Agent : Mozilla Thunderbird
On 8/25/2024 4:31 PM, Bob La Londe wrote:
On 8/24/2024 10:00 AM, Bob La Londe wrote:
Silly setup, but it worked.
>
https://www.yumabassman.com/wp-content/uploads/2024/08/Setup.jpg
>
I went ahead and ordered an inexpensive (cheap) one of these.
https://www.yumabassman.com/wp-content/uploads/2024/08/ER11-R8.webp
Even if its not fantastic and wonderful its got to be better than an 8mm x 120mm straight shank. It might even get here as I am finishing this batch of molds. LOL.
... or it might be a waste of time if the tool holder nose is to close to the spindle nose or quill shoulder. I guess I'll just have to wait and see.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Silly Setup
Re: Silly Setup