Re: Emerson Horizontal bandsaw?

On 8/26/2024 4:16 AM, Jim Wilkins wrote:

"Bob La Londe"  wrote in message news:vagk30$25f4n$1@dont-email.me...
 ...I've had a 7x12 from Harbor
Freight I've been using for years, and before that I had a Harbor
freight 4 x 6 I modified to cut 4 x 8 that I used for years before it
stripped a gear.  ...
-------------------------------------------
The 4x8 mod I made to my 4x6 is angle iron attached behind the fence, which was milled parallel on the back edge so that pressing it against the added angle quickly re-squares it after making angled cuts. Also I drilled extra holes that let the fence sit closer to the blade when square, to clamp smaller work, and replaced the small wheels with larger ones on an axle through the base. Being further apart they somewhat increase its stability when I roll it outdoors over the door threshold and down the sloping driveway.
 The next pieces I expect to cut on it are 20' long. That job will definitely happen outdoors , possibly back in the woods where the timbers are stored.
 The disadvantage of the 8" mod is loss of clearance for chips to escape the blade before entering the guide rollers. That doesn't matter as much when cutting wood. The widest I can clamp on the mill is 6-7/8" in the drill press vise and a 1" parallel will add chip clearance to cut a steel blank up to that size on the saw
 

I moved the original fence to a solid location for 8", and then made a new fence for the regular position with a tooless screw/handle for angle cuts.  Most of the time I do not use the original fence in its new locations.  Maybe never since I got the 7x12 bandsaw for larger stock.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com