Sujet : Re: yardsalin' again
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 06. Sep 2024, 22:41:47
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vbfsur$vcb3$1@dont-email.me>
References : 1 2
User-Agent : Mozilla Thunderbird
On 9/6/2024 1:19 PM, Snag wrote:
On 9/6/2024 2:44 PM, Snag wrote:
This time the Big Score is a 3 inch 3 jaw chuck on a 5c collet back plate with 3 sets of jaw (all fit) for the princely sum of 10 bucks . A piece of material for a 1 1/2-8 back plate will probably cost more than the chuck . Also got a couple of open/reversible ratchet shorty wrenches for a buck each .
As expected , a piece of 1045 jut the right size set me back $17.50 . A fully machined back plate would be over 50 bucks ...
You have a back plate that fits into a 5C spindle? I have a lathe with a 5C native spindle. Maybe we could horse trade... if I had a horse.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
yardsalin' again
Re: yardsalin' again
